« previous next »
Pages: [1]   Go Down

Author Topic: How to configure DevPak updater/installer in CodeBlocks13.12 (Windows 7)  (Read 4957 times)

Offline serge17

  • Single posting newcomer
  • *
  • Posts: 6
How to configure DevPak updater/installer in CodeBlocks13.12 (Windows 7)
« on: July 08, 2014, 06:18:50 pm »
Hello

When I try to configure DevPak updater/installer I fall on a warning (see below)

What can I do?                  

Thanks for an answer.
« Last Edit: July 08, 2014, 06:22:53 pm by serge17 »
Logged

Offline stahta01

  • Lives here!
  • ****
  • Posts: 7785
    • My Best Post
Re: How to configure DevPak updater/installer in CodeBlocks13.12 (Windows 7)
« Reply #1 on: July 08, 2014, 06:35:05 pm »
For this and other reasons; I do NOT trust the devpaks enough to install them any more.
I am thinking of making my own Devpak repository; but, that is in the future.

NOTE: IIRC, Boost needs to be built with the about the same Tool Chain (Compiler/Linker/Etc.) for it to work with your Tool Chain.

Tim S.
Logged
C Programmer working to learn more about C++ and Git.
On Windows 10 64 bit and Windows 11 64 bit.
--
When in doubt, read the CB WiKi FAQ. http://wiki.codeblocks.org

Offline serge17

  • Single posting newcomer
  • *
  • Posts: 6
Re: How to configure DevPak updater/installer in CodeBlocks13.12 (Windows 7)
« Reply #2 on: July 08, 2014, 07:53:39 pm »
Hello Tim

Thanks a lot for your answer. I'll try to get Boost by hand: but I am very far to be an expert...

Best

Serge
Logged
Pages: [1]   Go Up
« previous next »