« previous next »
Pages: [1]   Go Down

Author Topic: Arduino: upload  (Read 11514 times)

Offline AZ

  • Almost regular
  • **
  • Posts: 151
Arduino: upload
« on: November 17, 2016, 03:26:54 pm »
Getns,
 how do i configure the CB to upload the firmware?
 I noticed there was a flag in "Arduino" template, but i didn't set it when i was creating the project.
Logged
CB: nightly build .
Thread model: posix
gcc version 5.1.1 20150618 (Red Hat 5.1.1-4) (GCC)

Offline oBFusCATed

  • Developer
  • Lives here!
  • *****
  • Posts: 13406
    • Travis build status
Re: Arduino: upload
« Reply #1 on: November 17, 2016, 09:26:27 pm »
It is post build step. You give it a serial/usb port in the wizard.
Then you just build and if the arduino is connected it will try to upload it.
On linux it uses avrdude.
Logged
(most of the time I ignore long posts)
[strangers don't send me private messages, I'll ignore them; post a topic in the forum, but first read the rules!]

Offline AZ

  • Almost regular
  • **
  • Posts: 151
Re: Arduino: upload
« Reply #2 on: November 17, 2016, 10:40:33 pm »
Quote from: oBFusCATed on November 17, 2016, 09:26:27 pm
It is post build step. You give it a serial/usb port in the wizard.
Then you just build and if the arduino is connected it will try to upload it.
On linux it uses avrdude.

Right, but where do i configure this if i didn't check the flag in the wizard?
Logged
CB: nightly build .
Thread model: posix
gcc version 5.1.1 20150618 (Red Hat 5.1.1-4) (GCC)

Offline oBFusCATed

  • Developer
  • Lives here!
  • *****
  • Posts: 13406
    • Travis build status
Re: Arduino: upload
« Reply #3 on: November 18, 2016, 12:16:41 am »
Check the compiler variables?
Make another project and use a diff-tool or compare the settings in the UI.
Logged
(most of the time I ignore long posts)
[strangers don't send me private messages, I'll ignore them; post a topic in the forum, but first read the rules!]

Offline AZ

  • Almost regular
  • **
  • Posts: 151
Re: Arduino: upload
« Reply #4 on: November 18, 2016, 05:50:05 am »
Quote from: oBFusCATed on November 18, 2016, 12:16:41 am
Check the compiler variables?
Make another project and use a diff-tool or compare the settings in the UI.

oh. thank you!
I see it now.
Logged
CB: nightly build .
Thread model: posix
gcc version 5.1.1 20150618 (Red Hat 5.1.1-4) (GCC)
Pages: [1]   Go Up
« previous next »