Sorry I have just done it
Sorry again and thanks a lot.
Pascual.
Can you briefly explain which steps you have done ?
1. get all the packages for building like build-essential , autotools etc
2. compile wxGTK / install wxGTK
3. check the setup.h , the line wxUSE_UNICODE should be set to 1.
4. make sure wx-config is in the search path , can be confirmed using "which wx-config"
make sure that the your user id have the rights to read/write wxGTK path
download the CB source and put under your /usr/home/codeblocks
you need to use dos2unix to convert the source to unix-compatible format.
you can search the thread in Linux/Unix section , there is a thread about compilation of CB under debian , use that as a guide to compile
basically the CB compilation steps are
./bootstrap
./configure
./make
./make install <- this one need to use sudo