Code::Blocks Forums

Developer forums (C::B DEVELOPMENT STRICTLY!) => Development => Topic started by: MP2E on December 16, 2007, 02:15:03 am

Title: Compiling as Unicode in Slackware
Post by: MP2E on December 16, 2007, 02:15:03 am

How would I go about compiling codeblocks in unicode? I'm using Slackware 12, although generic linux instructions will do the trick.

Title: Re: Compiling as Unicode in Slackware
Post by: stahta01 on December 16, 2007, 02:40:30 am

Look at Wiki
http://wiki.codeblocks.org/index.php?title=Installing_Code::Blocks

Installing Code::Blocks from source on Linux (applies to all distros)
Installing Code::Blocks before SVN 3893 from source on Linux (applies to all distros)

Note: I just updated "Installing Code::Blocks from source on Linux" yesterday; And, I have not verified that they are right. I copied the old instructions to "Installing Code::Blocks before SVN 3893 from source on Linux"

Trying to install on Foresight Linux myself and having autoconfig/m4 issues.

Tim S

PS: This forum is for doing development of Code::Blocks not using Code::Blocks
Please use forum
http://forums.codeblocks.org/index.php/board,1.0.html for simple questions on Installing Code::Blocks

Title: Re: Compiling as Unicode in Slackware
Post by: MP2E on December 17, 2007, 12:28:35 am

I've done EVERYTHING in both wiki's but the build ALWAYS turns out ANSI instead of Unicode! I've tried a good 4 times, recompiling both wxGTK and Code::Blocks each time! :x