51
Embedded development / Re: Setting AVR Fuses in C code
« Last post by mikejp56 on April 11, 2024, 02:07:24 am »Hi stahta01,
Thanks for that. I tried googling but I came up pretty empty.
What I did figure out was that I need to put Fuses = and then some braces and then I cannot figure out how to enter the fuse parameters and the correct syntax. Any guidance would be greatly appreciated.
Thanks.
Regards,
mikejp56
Thanks for that. I tried googling but I came up pretty empty.
What I did figure out was that I need to put Fuses = and then some braces and then I cannot figure out how to enter the fuse parameters and the correct syntax. Any guidance would be greatly appreciated.
Thanks.
Regards,
mikejp56