Code::Blocks Forums
User forums => Embedded development => Topic started by: AZ on November 17, 2016, 03:26:54 pm
-
Getns,
how do i configure the CB to upload the firmware?
I noticed there was a flag in "Arduino" template, but i didn't set it when i was creating the project.
-
It is post build step. You give it a serial/usb port in the wizard.
Then you just build and if the arduino is connected it will try to upload it.
On linux it uses avrdude.
-
It is post build step. You give it a serial/usb port in the wizard.
Then you just build and if the arduino is connected it will try to upload it.
On linux it uses avrdude.
Right, but where do i configure this if i didn't check the flag in the wizard?
-
Check the compiler variables?
Make another project and use a diff-tool or compare the settings in the UI.
-
Check the compiler variables?
Make another project and use a diff-tool or compare the settings in the UI.
oh. thank you!
I see it now.