User forums > Nightly builds

The 16 October 2007 build (4540) is out.

<< < (2/3) > >>

pdsonic:
Hi,

I'm using wxSmith and on my panels/frames I use wxStaticBitmaps. The application is built for (and developed on) winXP and linux (freespire). The problem I have is that if I set the (relative) path in the wxSmith image editor so I can see the image at development time, then the image doesn't show in either windows and/or linux without some tricks.

Long story short... Is it possible for the image editor to use wxStandardPaths::GetResourcesDir for the base file path?

Or is there another way it can be done with the existing codeblocks?

Thanks in advance.  :idea:

pdsonic:
Don't worry about the above request.

I've solved the problem.   :)  I'm using wxSetWorkingDirectory to umm... set the working directory...

and I'm using the wxConfigBase::Create() and Read/Write methods to store the path to my graphic folder.


Thanks.

reptils:
Hi killerbot, I have a little feature request.
I like the option Auto-hide message pane, very usefull! but I'd like to add a behavior change. When I compile and all is ok, the message panne auto-hide as specified in the options :)
Is possible to auto-hide message pane WHEN programmer just left clic on editor area or press a key? so keep the message pane showned until any event.This behavior option can be added with a check box.
Thank for your job.

ASJ:
Just an update on my "always rebuild completely" problem: it seems that this not only happens when I try to debug: also when just "building", a complete rebuild takes place.
Because I did not see any comparable problem around here, most likely it is a problem on my side. Any suggestions what I might be doing wrong?

three_minute_hero:
Hi,

C::B svn 4540 crashes (i.e. closes immediately) when creating new project under Debian.

Navigation

[0] Message Index

[#] Next page

[*] Previous page