User forums > Help

GNU ARM cross compile fails

<< < (2/2)

MortenMacFly:

--- Quote from: rekisum on October 25, 2006, 05:05:34 pm ---Then, under 'Settings/Environment/Environment Variables' I add
PATH=D:\Programs\WinARM\bin;D:\Programs\WinARM\utils\bin

--- End quote ---
This is correct in principle, but a semi-colon in an envvar is not supported (currently, for internal reasons).


--- Quote from: rekisum on October 25, 2006, 05:05:34 pm ---Maybe I misunderstand the concepts of CB here.
Where should these parameters be stored?

--- End quote ---
I'm afraid, yes. To configure the path to the compiler you have to go to Settings -> Compiler and Debugger -> Tab "Programs" -> Point to the base path of the compiler there (D:\Programs\WinARM in your case, "bin" will be added automatically by C::B). Then goto Tab "Additional Path" (on the same tab) -> there you can enter "D:\Programs\WinARM\utils\bin". Notice that for the second you have to add the "bin", too.
With regards, Morten.

Navigation

[0] Message Index

[*] Previous page