User forums > Nightly builds

The 09 July 2006 build is out.

<< < (2/5) > >>

Jewe:

--- Quote from: Mr. Awesome on July 10, 2006, 09:32:15 am ---Just installed this build over my last one from a few months ago, and when I open CB I get the following error:

The procedure entry point _ZNK7wRegEx7MatchesEPKwij could not be located in the dynamic link library wxmsw26u_gcc_cb.dll.

WinXP SP-2

--- End quote ---
Did you also install the latest wxwidgets dll?

Jewe:
wxsmith wizard does not understand ok.

reproduction:
1. start c::B
2. new project
3. wxsmith
4. set the config. (any config)
5. press ok.. you can press ok and ok and ok and ok..

thomas:

--- Quote from: zhangxingcun on July 10, 2006, 09:23:41 am ---...
--- End quote ---
Ignore them. These are normal wxWidgets warnings.



--- Quote from: Mr. Awesome on July 10, 2006, 09:32:15 am ---The procedure entry point _ZNK7wRegEx7MatchesEPKwij could not be located in the dynamic link library wxmsw26u_gcc_cb.dll.
--- End quote ---
The error pretty much tells you what you need to do

Jewe:
find and replace is not working as expected.

reproduction:
1. take a copy of a source file
2. make the copy read only.
3. open it in C::B without a project.
4. find and replace some text.

result: no text has been changed and no warning/reason why not.

using:
XP sp2 and this build.

sethjackson:

--- Quote from: Jewe on July 10, 2006, 11:17:20 am ---find and replace is not working as expected.

reproduction:
1. take a copy of a source file
2. make the copy read only.
3. open it in C::B without a project.
4. find and replace some text.

result: no text has been changed and no warning/reason why not.

using:
XP sp2 and this build.

--- End quote ---

You knowingly opened a read-only file, and you want C::B to tell you that you did so when you try to "edit" (search, and replace) in it?  :shock:

Navigation

[0] Message Index

[#] Next page

[*] Previous page