User forums > Nightly builds
The 12 October 2014 build (9958) is out.
teto:
In fact if I close a project and reopen it afterwards, it loads with
the correct/saved pane layout (=the feature works).
The problem appears when I close codeblocks and reopen it: whatever
the project I only get one pane.
I've sent you a test project via mail.
At first I thought browseTracker was rewriting the layout to save
points so I disabled all plugins but it didn't change anything.
EDIT: I tried removing the layout, no change whatsoever
teto:
One more precision I just found out: if I close the project before closing codeblocks, reopen codeblocks and reopen the project then the feature works. In fact it fails to work only when the project remains open when I close codeblocks. Maybe this is due to my codeblocks config.
Jenna:
--- Quote from: teto on October 13, 2014, 05:38:21 pm ---One more precision I just found out: if I close the project before closing codeblocks, reopen codeblocks and reopen the project then the feature works. In fact it fails to work only when the project remains open when I close codeblocks. Maybe this is due to my codeblocks config.
--- End quote ---
Just a shot in the dark:
Did you ever save the default workspace ?
Or dp you have "Settings -> Environment -> General settings -> On application start-up -> Open default workspace" set ?
If yes can you set it to "Open blank workspace" and try it again ?
oBFusCATed:
What OS are you using?
Are you able to close codeblocks without a crash?
Jenna:
--- Quote from: jens on October 13, 2014, 08:52:45 pm ---
--- Quote from: teto on October 13, 2014, 05:38:21 pm ---One more precision I just found out: if I close the project before closing codeblocks, reopen codeblocks and reopen the project then the feature works. In fact it fails to work only when the project remains open when I close codeblocks. Maybe this is due to my codeblocks config.
--- End quote ---
Just a shot in the dark:
Did you ever save the default workspace ?
Or dp you have "Settings -> Environment -> General settings -> On application start-up -> Open default workspace" set ?
If yes can you set it to "Open blank workspace" and try it again ?
--- End quote ---
If it is what I think (default workspace), it should be fixed in trunk (svn r9986)..
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version