User forums > Help

Procedure entry point problem

(1/5) > >>

killerbot:
A few days ago, I had problems building on my laptop (see this thread higher up, with the resouce compiler and includes), I deleted my dfault.conf, and now I can build it again, that's the good news.

But when todays build (rev 1664) starts up I get the following message boxes (7 or 8 times) :
The procedure entry point _ZN7Manager3GetEP7wxFrameP10wxNotebookP8wxWindow could not be located in the dynamic link library codeblocks.dll. And I have done the update.bat (so did no forget that one).
Any ideas on what could have gone wrong this time ???

Lieven

rickg22:
hmmm try a full rebuild?

mandrav:

--- Quote from: Ceniza on January 06, 2006, 06:12:28 pm ---The evil bug attacks again!

Try this: in the messages dock select "Build log", close Code::Blocks and open it again. Now "Build log" will be the first tab and 3 (Code::Blocks, Code::Blocks Debug and Search Results) will be "hidden".

--- End quote ---

Fixed.


--- Quote from: killerbot on January 06, 2006, 07:25:31 pm ---Any ideas on what could have gone wrong this time ???

--- End quote ---

When the SDK changes, make sure you build the contrib plugins with it ;)
(these are debug messages when trying to load the contrib plugins which are linked with an older codeblocks.dll)

killerbot:
thanks Yiannis, I just remembered myself.

eranif:
Mandrav,

From reading here - I see that some bug are poping up and being fixed by you (or others) can you please update the CVS with the bug fixes? So other people will get the fixes as well?

Thanks in advance,
Eran

Navigation

[0] Message Index

[#] Next page