User forums > Using Code::Blocks

*.am files changed in SVN - how to ?

(1/1)

tiwag:
if some *.am files have been changed in SVN,
what have i to do after updating ?

which of them (if any) do i have to run ?
./bootstrap
./configure

these are obligatory of course:
make
sudo make install

thx
( need still learning a lot about linux ... )

Der Meister:
As far as I know ./configure is enough. ./bootstrap needs to be done only if configure.in changes. And of course make and make install are always necessary. ;)

mandrav:
Usually, when any of these files change, just typing "make" gets the job done. So the answer is you don't have to do a thing.

tiwag:

--- Quote from: mandrav on December 29, 2005, 05:49:36 pm ---Usually, when any of these files change, just typing "make" gets the job done. So the answer is you don't have to do a thing.

--- End quote ---

pretty simple  :D

Navigation

[0] Message Index