User forums > Nightly builds

The 17 September 2011 build (7452) is out.

<< < (9/14) > >>

daniloz:
Just a hint, the Serach/Goto Function... does exactly this, i.e. sets the function name at the top of the editor...
But, I'm supposing that your patch does the same, right?

k1mgy:
Installed just a few days ago.. it has been a while (about 6 months) since I've updated from nightly!

Windows 7
CB: 7452

Every so often, perhaps every 2 minutes, CB will freeze during an editing session.  At this same time I notice that CB does not appear in the open program list when I ALT-TAB.

I turned off both code completion and symbols browser, as these in the past have caused delays.  However, the problem continues.

Any way someone can suggest to diagnose this?

stahta01:
@k1mgy:

Verify the problem still exists after turning off anti-virus software.

If it goes away, look for how to configure your AV right.

Tim S.

Jenna:

--- Quote from: stahta01 on September 24, 2011, 06:56:30 pm ---@k1mgy:

Verify the problem still exists after turning off anti-virus software.

If it goes away, look for how to configure your AV right.

Tim S.

--- End quote ---
And make sure, that no libs from an older nightly remain in C::B's (sub-)folder(s).

k1mgy:
@jens @tim
Thank you very much!

1. My anti-virus, Norton Internet Security 2012, had crashed (and I didn't know it).
2. Ran norton removal tool
3. Reinstalled anti virus
4. Applied update.
various reboots..

Now CB operates normally.
 
Perhaps it was Norton's check on program legitimacy that had failed and caused the delays?

Navigation

[0] Message Index

[#] Next page

[*] Previous page