User forums > Using Code::Blocks

Saving Toolchain Executables Info

(1/1)

pichlerd:
v10.05 running on XP

I have set up a tool chain were all information is being saved successfully except the Linker information.  I want this to be blanked out so that my programs do not link.  I go into tool chain and blank out the two linker fields and rebuild my project.  Everything works perfectly.  I exit C::B and come back in and the fields are filling in again.  I read on another post to try to load bring C::B and do nothing but update the toolchain and exit.  I did this with no success.  Is there a special way to save information on this panel? Or is there another value that I need to enter for my project not to link???

Thanks and best regards!

MortenMacFly:

--- Quote from: pichlerd on June 09, 2011, 07:00:28 am ---Or is there another value that I need to enter for my project not to link???

--- End quote ---
Just disable the compilation of the files in the file's properties and as it dos not compile it also won't link. You can alternatively setup a project of type "commands only".

Navigation

[0] Message Index