User forums > Using Code::Blocks

[ASK]After Installation

(1/1)

zlivkun:
hello there
several hours ago i've downloaded C::B 10.05 setup mingw
and installed it. then i created new file and write some codes
but when i want to build and run it,nothing happened
build log was empty, no comments or warning

i've been configure the setting compiler and debugger
but its remained the same
anybody know 'bout this problem??thx 4 ur attention :D

ollydbg:

--- Quote from: zlivkun on March 22, 2011, 11:08:16 pm ---then i created new file and write some codes
but when i want to build and run it,nothing happened
build log was empty, no comments or warning

--- End quote ---
what's the exact steps you did??

Navigation

[0] Message Index