User forums > Help

'Run' and Run part of 'Build and Run' not working...

<< < (3/4) > >>

stahta01:
The re-boot fix means, it is likely your EXE was already running in a non-responsive state.

Tim S.

MaxLondon:
I doubt that, as I (at least) triple checked in the task-manager that there was no running instance.

I could also start the .EXE using explorer or from cmd without a problem, and several instance in parallel.

If it comes up again (hope it doesn't ;-) I will check for a running process.

stahta01:
You should also check for gdb.exe if running with debugger.
I would also check for gcc/g++/ld tasks.

Tim S.

barbourwill:
I have exactly the same problem. Codeblocks was working fine for past week and now suddenly the IDE is incapable of invoking the executable that is created -> I just see a blank build log window. The compile and build works fine - I can successfully run the exe, just not from within the codeblocks ide.

I have tried restarting/re-installing codeblocks/ deleting the user config file all to no avail!

Anyone have any clues?

Jenna:

--- Quote from: barbourwill on November 13, 2010, 10:38:42 am ---I have exactly the same problem. Codeblocks was working fine for past week and now suddenly the IDE is incapable of invoking the executable that is created -> I just see a blank build log window. The compile and build works fine - I can successfully run the exe, just not from within the codeblocks ide.

I have tried restarting/re-installing codeblocks/ deleting the user config file all to no avail!

Anyone have any clues?


--- End quote ---
Which OS and which version of C::B ?

Navigation

[0] Message Index

[#] Next page

[*] Previous page