Developer forums (C::B DEVELOPMENT STRICTLY!) > CodeCompletion redesign

Difference from branch and trunk...

(1/2) > >>

daniloz:
Hello All,

I'm using both the svn branch and trunk versions and I see a big difference: the trunk version finds all my #defines and shows them in the symbols list and completion, but the branch version only finds some of them. I couldn't yet figure out which ones are in or out...

Any hints? Can anyone confirm this? Solutions? :D

Thx in advance...

Jenna:
trunk is the version used for nightlies, the features here are normally tested and stable, but may (of course) contain bugs.

If you say branch, you should specify more exactly which branch you use, there are several branches. The most of them are outdated, but new features, that change  essential parts of C::B are normally also tested in special test-branches.

daniloz:
branch = codecompletion_refactoring as in the section of the forum... :)

blueshake:
can you post the codes which are not parsed , so I  can check into it.

daniloz:
It's difficult because it's part of a big project, but I'll try to make a small test project out of it... it will take a couple of days though... sorry...

Navigation

[0] Message Index

[#] Next page