Developer forums (C::B DEVELOPMENT STRICTLY!) > Development
Splitting debugger in two - specific debugger and common GUI
oBFusCATed:
Thank you, I was that someone.
I'll look at it tonight or in the weekend...
MortenMacFly:
--- Quote from: oBFusCATed on January 21, 2011, 03:25:35 pm ---I'll look at it tonight or in the weekend...
--- End quote ---
Ok - so you will take care and tell me if it's working properly and is applied in the branch so I can close the ticket, please? :-)
oBFusCATed:
Yes, can you test it, too?
MortenMacFly:
--- Quote from: oBFusCATed on January 21, 2011, 04:39:23 pm ---Yes, can you test it, too?
--- End quote ---
I must admit that I never worked a lot with CDB, but I can try.
oBFusCATed:
--- Quote from: etheranger on January 21, 2011, 02:54:42 pm ---+ Added workaround to correctly set working dir (can still be disabled by #undefining ENABLE_WORKINGDIR_WORKAROUND.
--- End quote ---
Have you tried to pass the .create command in the -c command line option?
--- Quote ----c "command"
Specifies the initial debugger command to run at start-up. This command must be surrounded with quotation marks. Multiple commands can be separated with semicolons. (If you have a long command list, it may be easier to put them in a script and then use the -c option with the $<, $><, $><, $$>< (Run Script File) command.)
--- End quote ---
Hm, it seems that the breakpoints are a bit broken. The current position marker is displayed 1 line after the breakpoint.
Etheranger, Morten do you see this problem, too?
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version