Author Topic: Codeblocks 8.02 with Qt DLL.  (Read 1932 times)

ashken

  • Guest
Codeblocks 8.02 with Qt DLL.
« on: July 23, 2010, 02:40:57 pm »
How do i setup codeblocks IDE to access DLLs that are needed by application during testing?

Offline stahta01

  • Lives here!
  • ****
  • Posts: 6894
    • My Best Post
Re: Codeblocks 8.02 with Qt DLL.
« Reply #1 on: July 23, 2010, 03:00:58 pm »
I normally just add the path to the DLLs to the Compiler "additional paths" list.
Note: You need to remember to remove the path later.

The above is not as good as copying the DLLs to the execution folder; but, it seemed easier to me.

The above assumes the DLLs was not built by the Code::Blocks project and are not already in the system path.
If either is true, it should work without any changes.

Tim S.
« Last Edit: July 23, 2010, 03:03:10 pm by stahta01 »
C Programmer working to learn more about C++ and Git.
On Windows 7 64 bit and Windows 10 32 bit.
On Debian Stretch, compiling CB Trunk against wxWidgets 3.0.
--
When in doubt, read the CB WiKi FAQ. http://wiki.codeblocks.org